Data Programmer 200s

Legacy Page

The DP200s provides a message display area and push button keys to request data and/or make programming changes. The display is brightly illuminated for use in dark environments.

There are 6 push buttons to perform functions and 4 LEDs to enunciate certain conditions.:

* Key
Left Arrow Key
Up Arrow Key
Down Arrow Key
Left Arrow Key
Norm Key
Display Mode
Status Mode
Program Mode


The Display mode allows you to:

Display weld data for the last weld performed (or the last weld of a particular weld sequence.)
Display a short version of the weld sequence so that quick changes can be made to the existing sequence.

The Status Mode allows you to:

View the status of the welding control's steppers.
View the I/O status of the weld control.
View the Fault status of the weld control
View the Network fault and communication status.
View the analog window data and current status.
View the Software Revision status for all devices on the network.
View the extended Hardware & Software Revision status for a selected device.

The Program Mode allows you to:

Program the weld controls welding schedules.
Program the weld controls welding steppers.
Program the weld controls setup parameters.
Program the weld controls analog calibration data.
Reload the weld controls default settings for it's welding schedules, steppers and setup parameters.